Toyota Rav4 1997 Manual Transmission Speed Sensor Location
Generally, a vehicle speed sensor should last well over 100,000 miles, and the average replacement frequency is closer to 150,000 miles, with exceptions. To prolong the life of your vehicle speed sensor, as well as all other components in your transmission, ensure you are maintaining the transmission in accordance with the owners manual service. Dec 12, 2016 Speed sensor location Toyota Camry years 1990 to 2002 - Duration. 1997-2001 2.2L Camry automatic transmission removal pt1 - Duration: 20:01. Rust Belt Auto 31,199 views. Shop 1997 Toyota RAV4 Vehicle Speed Sensor. Sensor, Speedometer. A sensor, located on a vehicle's Transmission, Transaxle - OEM Toyota Part #. View and Download Toyota RAV4 1997 owner's manual online. Toyota RAV4 1997. RAV4 1997 Automobile pdf manual download. Toyota RAV4 1997 Owner's Manual. Toyota rav4 1997. The set speed. When you release it, the ve- hicle will return to the speed set prior to the acceleration. CAUTION For manual transmission: While driving with the cruise. May 01, 2016 My Rav4.2 suffered for a couple of years each winter from speedometer failure when 'T he speed sensor plug near the back of the gearbox when viewed from under the bonnet - close to the drive shafts' gets wet from rain water - not surprising it being located so low down. WD40 was not a permanent fix, I got tired of failures so I removed orange seal and replaced it with an 'O' ring 3mm, thick. Get the best deals on Automatic Transmission Parts for 1997 Toyota RAV4 when you shop the largest online selection at eBay.com. Free shipping on many items. Vehicle Speed Sensor-Manual Trans Speed Sensor Pioneer SPS-1365 (Fits: 1997 Toyota RAV4). Item Location.
- Toyota Rav4 Transmission Problems
- Toyota Rav4 Oxygen Sensor Location
- 2002 Toyota Rav4 Transmission Recall
- Toyota Speed Sensor Location
Components
Removal
Toyota RAV4 Standard Transmission 1997, Manual Transmission Speed Sensor by Beck Arnley®. For one hundred years, Beck/Arnley has been providing premium OE quality parts for vehicles. Beginning with motorcycle parts in 1914.
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove battery
- Loosen the nut and remove the bolt and battery clamp.
- Remove the battery.
- Remove the battery tray.
- Remove the 4 bolts and battery carrier.
- Remove the 2 bolts and battery bracket reinforcement.
- Remove speed sensor nt
- Disconnect the sensor connector.
- Remove the bolt and sensor.
- Remove the o-ring from the sensor.
- Remove speed sensor nc
- Disconnect the sensor connector.
- Remove the bolt and sensor.
- Remove the o-ring from the sensor.
Inspection
- Inspect speed sensor nt
Measure the resistance of the sensor.
Standard resistance
- Inspect speed sensor nc
Toyota Rav4 Transmission Problems
Measure the resistance of the sensor.
Standard resistance
Installation
- Install speed sensor nc
- Coat a new o-ring with atf.
- Install the o-ring to the sensor.
- Install the sensor with the bolt.
Torque: 11 n*m (112 kgf*cm, 8 ft.*Lbf)
- Connect the sensor connector.
- Install speed sensor nt
- Coat a new o-ring with atf.
- Install the o-ring to the sensor.
- Install the sensor with the bolt.
Torque: 11 n*m (112 kgf*cm, 8 ft.*Lbf)
- Connect the sensor connector.
- Install battery
- Install the battery bracket reinforcement with the 2 bolts.
Torque: 20 n*m (204 kgf*cm, 15 ft.*Lbf)
Toyota Rav4 Oxygen Sensor Location
- Install the battery carrier with the 4 bolts.
2002 Toyota Rav4 Transmission Recall
Torque: 20 n*m (204 kgf*cm, 15 ft.*Lbf) Free online mercedes repair manual.
Toyota Speed Sensor Location
- Install the battery tray.
- Install the battery with the battery clamp.
Torque: 8.5 N*m (87 kgf*cm, 75 in.*Lbf) for bolt
5.0 N*m (51 kgf*cm, 44 in.*Lbf) for nut
- Connect cable to negative battery terminal
Automatic transaxle fluid
On-vehicle inspection Check transaxle fluid level Hint: Drive the vehicle so that the engine and transaxle are at normal operating temperature. Fluid temperature: 70 to 80В°c (158 to 176В°f ..Transmission wire
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to preven ..Other materials:
Precaution
Troubleshooting precaution When there are malfunctions in the contact points of the terminals or installation problems with any parts, removal and installation of the suspected problem parts may return the system to its normal condition either entirely or temporarily. In order to ..
Pig power supply voltage malfunction
Description When a problem occurs in the system, the power source relay circuit is shut off to stop the power assist. Wiring diagram Inspection procedure Read value of intelligent tester (pig power supply) Connect the intelligent tester (with can vim) to the dlc3. Turn ..
Correct driving posture
Adjust the angle of the seatback so that you are sitting straight up and so that you do not have to lean forward to steer. Adjust the seat so that you can depress the pedals fully and so that your arms bend slightly at the elbow when gripping the steering wheel. Lock the head ..